Leica mojo3D, Correction Sources 207
11. If the connection was successful, tap to complete the Network DGPS config-
uration and begin using the system. You are returned to the main navigation
screen.
8. Select a stream by tapping its name. Information about the stream appears on
the right side of the screen.
The distance to the reference source shown on the right is a guide only and
may be incorrect. Some servers provide a virtual correction location that
can only be assigned to a location close to you once you have connected
to the data stream. Until that time, the reported distance is meaningless.
9. Once a stream is selected, tap the button.
10. If all details are entered correctly,
the system attempts to connect to
the correction source. This may take
some time and if successful the
Correction Source Status screen
appears with a in front of
Correction Source Status.
To Next Page
Loading...
Need help?
General
