Leica mojo3D, Running the mojo3D for the First Time 53
2. In each column, tap an item for display. Left-to-right order on this screen trans-
lates to top-to-bottom order on the main navigation screen.
• Tap Total Area to select the total area enclosed by the field boundary to be
displayed.
• Tap Remaining to select the approximate area remaining within the field
boundary to be displayed.
The area remaining is calculated as the total field boundary area less the
recorded amount of coverage excluding overlap. The remaining area may
not be accurate if large amounts of area has been covered outside the field
boundary.
3. To set the odometer display to zero, tap the reset odometer
button at the right of the screen.
4. Tap to return to the main navigation screen.
To Next Page
Loading...
Need help?
General
