Page 185
MegaRAID SAS Software User Guide Chapter 5: MegaRAID Command Tool
| Controller Property-Related Options
5.8.6 Display Specified Controller
Properties
Use the command in the following table to display specified properties on the selected
controller(s).
NOTE: The tty log can be saved at the controller level.
5.8.7 Set Factory Defaults Use the command in the following table to set the factory defaults on the selected
controller(s).
5.8.8 Set SAS Address Use the command in the following table to set the SAS address on the selected
controller(s).
5.8.9 Set Time and Date on
Controller
Use the command in the following table to set the time and date on the selected
controller(s).
Table 42: Display Specified Controller Properties
Convention MegaCli –AdpGetProp CacheFlushInterval | RebuildRate | PatrolReadRate| BgiRate |
CCRate | ReconRate | SpinupDriveCount | SpinupDelay | CoercionMode |
PredFailPollInterval | ClusterEnable | BatWarnDsbl | EccBucketSize | EccBucketLeakRate
| EccBucketCount | AlarmDsply | AbortCCOnError | AutoDetectBackPlaneDsbl |
CopyBackDsbl | LoadBalanceMode | SMARTCpyBkEnbl | SSDSMARTCpyBkEnbl |
MaintainPdFailHistoryEnbl | EnblSpinDownUnConfigDrvs | EnblSSDPatrolRead | NCQDsply |
UseFDEOnlyEncrypt | WBSupport | AutoEnhancedImportDsbl | PrCorrectUncfgdAreas |
DsblSpinDownUnConfigDrvs | -aN|-a0,1,2|-aALL
Description Displays the properties on the selected controller(s).
EccBucketCount: Count of single-bit ECC errors currently in the bucket.
WBSupport: Enables support for the WriteBack option as the Write Policy.
DsblSpinDownUnConfigDrvs: Disable spindown of unconfigured drives.
See Table 41 for explanations of the other options.
Table 43: Set Factory Defaults
Convention MegaCli -AdpFacDefSet -aN|-a0,1,2|-aALL
Description Sets the factory defaults on the selected controller(s).
Table 44: Set SAS Address on Controller
Convention MegaCli –AdpSetSASA str[0-64] -aN
Description Sets the controllers SAS address. This string must be a 64-digit hexadecimal
number.
Table 45: Set Time and Date on Controller
Convention MegaCli –AdpSetTime yyyymmdd HH:mm:ss
-aN|-a0,1,2|-aALL
Description Sets the time and date on the controller. This command uses a 24-hour
format.
For example, 7 p.m. displays as 19:00:00. The order of date and time is
reversible.
To Next Page
Loading...
Need help?
General