EasyManuals Logo

Lenovo ThinkSystem DM5000 series User Manual

Lenovo ThinkSystem DM5000 series
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
Step 1. At the storage system prompt, switch to the LOADER prompt: halt
Step 2. Enter the following command at the LOADER prompt: boot_diags
Note: You must run this command from the LOADER prompt for system-level diagnostics to
function properly. The bboooott__ddiiaaggss command starts special drivers designed specifically for
system-level diagnostics.
Step 3. Run diagnostics on all the devices by entering the following command: sldiag device run
Step 4. View the status of the test by entering the following command: sldiag device status
Your storage system provides the following output while the tests are still running:
There are still test(s) being processed.
After all the tests are complete, the following response appears by default:
*> <SLDIAG:_ALL_TESTS_COMPLETED>
Step 5. Identify the cause of the system sluggishness by entering the following command: sldiag device
status -long -state failed
Example
The following example shows how the full status of the failures is displayed in a test run without the
appropriate hardware:
*> sldiag device status -long -state failed
TEST START ------------------------------------------
DEVTYPE: nvram_ib
NAME: external loopback test
START DATE: Sat Jan 3 23:10:55 GMT 2009
STATUS: Completed
ib3a: could not set loopback mode, test failed
END DATE: Sat Jan 3 23:11:04 GMT 2009
LOOP: 1/1
TEST END --------------------------------------------
TEST START ------------------------------------------
DEVTYPE: fcal
NAME: Fcal Loopback Test
START DATE: Sat Jan 3 23:10:56 GMT 2009
STATUS: Completed
Starting test on Fcal Adapter: 0b
Started gathering adapter info.
Adapter get adapter info OK
Adapter fc_data_link_rate: 1Gib
Adapter name: QLogic 2532
Adapter firmware rev: 4.5.2
Adapter hardware rev: 2
Started adapter get WWN string test.
Adapter get WWN string OK wwn_str: 5:00a:098300:035309
Started adapter interrupt test
Adapter interrupt test OK
Started adapter reset test.
Adapter reset OK
Started Adapter Get Connection State Test.
Connection State: 5
Loop on FC Adapter 0b is OPEN
Started adapter Retry LIP test
Chapter 7
. System level diagnostics 115

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenovo ThinkSystem DM5000 series and is the answer not in the manual?

Lenovo ThinkSystem DM5000 series Specifications

General IconGeneral
BrandLenovo
ModelThinkSystem DM5000 series
CategoryStorage
LanguageEnglish

Related product manuals