Verifying and setting the HA state of the controller module
You must verify the HA state of the controller module and, if necessary, update the state to match your
system configuration.
Step 1. In Maintenance mode from the new controller module, verify that all components display the same
HA state: ha-config show
If your system is in... The HA state for all components should be...
An HA pair
ha
Step 2. If the displayed system state of the controller module does not match your system configuration,
set the
HA state for the controller module: ha-config modify node ha-state
Step 3. If the displayed system state of the chassis does not match your system configuration, set the
HA
state for the chassis: ha-config modify chassis ha-state
Running system-level diagnostics
You should run comprehensive or focused diagnostic tests for specific components and subsystems
whenever you replace the controller.
52
ThinkSystem DM3000x and DM5000x Hardware Installation and Maintenance Guide
To Next Page
Loading...
Need help?
General