Remove the LCD diagnostics panel assembly
Use this information to remove the LCD diagnostics panel assembly.
About this task
Attention:
• Read Installation Guidelines to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Remove the top cover. See Remove the top cover.
Step 2. If the security bezel is installed, remove it. See Remove the security bezel.
Step 3. Remove the LCD diagnostics panel assembly.
Figure 40. LCD diagnostics panel assembly removal
a. Press down the extended tab on the other side of the front chassis.
b. Slide the assembly out of the front chassis.
After you finish
1. Install a new LCD diagnostics panel assembly or filler. See Install the LCD diagnostics panel assembly.
2. If you are instructed to return the old LCD diagnostics panel assembly, follow all packaging instructions
and use any packaging materials that are provided.
120
ThinkSystem SR645 Maintenance Manual
To Next Page
Loading...
