Install the internal CFF RAID/HBA adapter
Use this information to install the internal CFF RAID/HBA adapter.
About this task
Attention:
• Read Installation Guidelines to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Touch the static-protective package that contains the internal CFF RAID/HBA adapter to any
unpainted surface on the outside of the server. Then, take the internal CFF RAID/HBA adapter out
of the package and place it on a static-protective surface.
Step 2. Align the notches on the tray with the pins on the chassis, place down the internal CFF RAID/HBA
adapter, and slightly slide it as shown to secure it on the chassis.
Figure 71. Internal CFF RAID/HBA adapter installation
Step 3. Connect cables to the internal CFF RAID/HBA adapter.
After you finish
Complete the parts replacement. See Complete the parts replacement.
Chapter 4. Hardware replacement procedures 167
To Next Page
Loading...
