4 x 2.5-inch front drive bays (SAS/SATA)
The server model is configured with one 4 x 2.5-inch SAS/SATA front drive backplane. Below lists all
supported configurations with this front drive backplane.
Configuration option
Storage controller
Qty. Type
Config. 1
Config. 2
1 SFF 8i RAID/HBA
Depending on your server configurations, refer to one of the following sections for cable routing information.
Configuration 1 and 2: (front drive bays only)
Config.
Front BP
System board
Storage controller
SFF 8i RAID/HBA
1 SAS 0 PCIe 2
2
SAS 0, SAS 1
Gen 4: C 0
Gen 3: C 0, C 1
The following illustration shows the cable routing for the configuration 2, the routing for configuration 1 is
similar. Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Note: For models that support Gen 3 and Gen4 adapters in the same slot, the illustration shows only the
cable routing information for Gen 4 adapters, the routing and connector information is similar for Gen 3
adapters.
Figure 17. Cable routing for configuration 2
Chapter 3. Internal cable routing 67