Remove the RAID super capacitor module on the riser
Use this information to remove the RAID super capacitor module on the riser.
About this task
Attention:
• Read Installation Guidelines to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Remove the top cover. See Remove the top cover.
Step 2. Disconnect the cable of the RAID super capacitor module.
Step 3. Remove the riser assembly. See Remove a riser card.
Step 4. Remove the RAID super capacitor module from the riser.
Figure 110. Removal of the RAID super capacitor assembly from the riser
a. Rotate the latch on the riser bracket to the open position.
b. Remove the RAID super capacitor assembly from the riser.
c. Open the retention clip on the holder of the RAID super capacitor module.
d. Take the RAID super capacitor module out of the holder.
After you finish
If you are instructed to return the old RAID super capacitor module, follow all packaging instructions and use
any packaging materials that are provided.
Chapter 4. Hardware replacement procedures 215
To Next Page
Loading...
