Complete the parts replacement
Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component inInternal cable routing.
3. If you have removed the top cover, reinstall it. See Install the top cover.
4. Reconnect external cables and power cords to the server.
Attention: To avoid component damage, connect the power cords last.
5. Update the server configuration if necessary.
• Download and install the latest device drivers:
http://datacentersupport.lenovo.com
• Update the system firmware. See Firmware updates.
• Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID if you have installed or
removed a hot-swap drive, a RAID adapter, or the M.2 adapter and M.2 drive. For more information,
see:
https://sysmgt.lenovofiles.com/help/topic/LXPMv3/LXPMv3_introduction.html
Chapter 4. Hardware replacement procedures 241
To Next Page
Loading...
