If you are planning to recycle the system board, follow the instructions in Hardware disassembling for recycle
for compliance with local regulations.
Install the system board
Use this information to install the system board.
About this task
Attention:
• Read Installation Guidelines to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku: http://list.youku.com/albumlist/show/id_52339628
Procedure
Step 1. Touch the static-protective package that contains the system board to any unpainted surface on
the outside of the server. Then, take the system board out of the package and place it on a static-
protective surface.
Chapter 4. Hardware replacement procedures 233
To Next Page
Loading...
