Step 4. Remove the heat sink.
Figure 89. Heat sink removal
a. Loosen the two screws in the front of the T-shaped heat sink.
b. Use a Torx #T20 screwdriver to loosen all the captive screws in the removal sequence shown
on the heat-sink label. After loosening each captive screw, wait for several seconds for the
heat sink to loosen from the processor.
c. Slightly lift the heat sink away from the system.
After you finish
• If you are replacing a heat sink, install a new heat sink. See Install a T-shaped heat sink.
• If you are replacing a processor, remove the processor. See Remove a processor.
194
ThinkSystem SR645 Maintenance Manual
To Next Page
Loading...
