Figure 129. Disassembling the system board
Step 1. Remove the following screws as illustrated:
• 12 slotted screws (with PH2 screwdriver)
• Two guiding pin standoffs (with 7 mm wrench)
• One plunger (with 11 mm and 16 mm wrench)
• Eight T20 screws on the CPU sockets (with T20 screwdriver)
• Two hexagon bolts on the VGA connector (with 5 mm wrench)
Step 2. Separate the components
1 2 3 4 5 6 7 from the system board.
After disassembling the system board, comply with local regulations when recycling.
262
ThinkSystem SR645 Maintenance Manual
To Next Page
Loading...
