Step 4. Install the super capacitor module.
Figure 137. Installing the super capacitor module
1. Put a super capacitor module into the holder, and press it down to secure it into the holder.
2. Align the pins on the metal cover with the holes in the super capacitor holder, pull out the blue
latch on the cover, and slide the cover into the holder until the pins pass through the holes.
Then, release the blue latch to lock the cover into place.
Step 5. Connect the super capacitor module to an adapter with the extension cable that comes with the
super capacitor module. See “RAID super capacitor modules” on page 62.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 397
Chapter 4. Hardware replacement procedures 299
To Next Page
Loading...
