Lenze i510 Series

Keypad Full Control
Use the
CTRL
keypad key to acvate the "Keypad Full Control" control mode. Both the control
and the setpoint selecon are then made via the keypad. This special control mode can be, for
instance, used during the commissioning phase if external control and setpoint sources are
not ready to use yet.
NOTICE
If the "Keypad Full Control" control mode is acve, the "Run" 0x2631:002 (P400.02) funcon is
internally set to TRUE.
In this case, the motor cannot be stopped via this funcon.
▶
For stopping the motor, use the keypad key, deacvate the inverter enable or acvate
the "quick stop" funcon.
•
Aer the
CTRL
key has been pressed, the acvaon of the control mode must be con-
rmed with the key. (The key serves to cancel the acon.)
•
When the control mode is changed over, the motor is rst stopped and the "Forward"
direcon of rotaon is set. Then, the motor can be started and stopped via the keypad.
MAN AUTO SETLOC REM
VEL:RUN:REV
0 0 0 - 3 7 4
MAN AUTO SETLOC REM
Keypad full ctrl?
0 0 0 O 2 O N
MAN AUTO SETLOC REM
FWD
0 0 0 S T O P
CTRL
MAN AUTO SETLOC REM
Hz
0 0 0 O 2 O O
VEL:KPDF:KPD
VEL:RUN:FWD
MAN AUTO SETLOC REM
0 0 W F F 8 5
Keypad full ctrl
Hz
If the "Keypad Full Control" control mode is acve,
•
the keypad shows the "Keypad full ctrl" warning alternately with the status display.
•
the set standard setpoint sources are ignored.
•
a change-over to other setpoint sources is not possible.
•
a change-over to network control is not possible.
•
the following funcons connue to be acve:
•
0x2631:001 (P400.01): Enable inverter
•
0x2631:003 (P400.03): Acvate quick stop
•
0x2631:005 (P400.05): Acvate DC braking
•
0x2631:010 (P400.10): Jog foward (CW)
•
0x2631:011 (P400.11): Jog reverse (CCW)
•
0x2631:013 (P400.13): Reverse rotaonal direcon
•
0x2631:043 (P400.43): Acvate fault 1
•
0x2631:044 (P400.44): Acvate fault 2
Clicking the
CTRL
keypad key stops the control mode again.
The keypad key
CTRL
•
directly changes the seng in 0x2602:003 (P708.03).
•
can be deacvated in 0x2602:001 (P708.01).
Addional funcons
Keypad
Keypad - Conguraon of R/F and CTRL buons
255