Lenze L-force CANopen EMF2178IB - Important Controller Codes

Codes
Important controller codes
14
l
144
EDSMF2178IB EN 3.0
14.3 Important controller codes
This section briefly describes the most important codes of the standard device for CAN
communication.
, Documentation for the basic drive
Here you can find detailed information on the codes of the standard device.
C0001:
Operating mode for 8200 vector
Code Subcode Index
Possible settings
Data type
Lenze Selection
C0001 − 24574 =
0x5FFE
0 see System Manual for 8200
vector
FIX32
The operating mode defines which source may currently write to which parameters.
The operating unit and CAN are always authorised for parameter setting.
) Note!
Please observe that the operating mode C0001 is contained in all parameter
sets. Therefore C0001 must be set equally in all parameter sets.
C0009:
CAN node address
Code Subcode Index
Possible settings
Data type
Lenze Selection
C0009 − 24566 =
0x5FF6
1 1 [1] 99 FIX32
Node address for unambiguous addressing of the device in a CAN network.
C0046:
Display of frequency setpoint
Code Subcode Index
Possible settings
Data type
Lenze Selection
C0046 − 24529 =
0x5FD1
g see documentation of the
standard device
FIX32