Lenze PROFINET 9400 - Page 117

Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17 117
Index
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
PROFIsafe 76
Protection against uncontrolled restart 51
Protection of persons 11
Protective insulation 18
Protocol data 16
Q
Querying the bus status 83
Querying the PROFINET status 83
R
Reading parameters from the inverter 61
Residual hazards 11
Resp. to comm. error with MXI1 (C01501) 92
Resp. to comm. error with MXI2 (C01502) 92
Resp. to imp. device config. (C00615) 91
Resp. to new module in MXI1 (C00636) 91
Resp. to new module in MXI2 (C00637) 92
Response time when exiting "Data_Exchange" (C13881) 99
Response time when exiting "Data_Exchange" (C14881) 108
Response to communication fault (C14880) 108
Restart by watchdog reset (error message) 86
Runtime delays 17
S
Safety communication timeout (error message) 89
Safety connect error (error message) 89
Safety init error (error message) 89
Safety instructions 10
Safety instructions (representation) 9
Safety parameter timeout (error message) 89
Screenshots/application examples 5
Setting the IP configuration 37
Setting the station name 35
Settings (C13860) 96
Settings (C14860) 105
Shared Device (function) 52
Siemens »Primary Setup Tool« 47
Siemens STEP7 (»hwconfig«) 43
Station name (C13899) 100
Station name (C14899) 109
Status displays (LEDs) 79
Status displays at X241 and X242 82
Structure of the Ethernet cable 29
Structure of the PROFINET data frame 60
Subnet Mask 41
Subnetwork mask (C13001) 93
Subnetwork mask (C14001) 102
Suppression diagnostic message (C13887) 100
Suppression diagnostic message (C14887) 109
Switch latency 15, 17
Switching method 15
System error messages 85
T
Table of attributes 111
Target group 5
TCP ports (number ) 15
TCP ports (number) 15
Technical data 15
Terminals 31
Terminology used 8
Type of node 15
U
Use of repeaters 25
User data assignment 60
User data length 33
Using the communication module 12
V
Voltage supply 15
Voltage supply (external) 31
W
Wiring according to EMC guidelines 24
Writing parameters to the inverter 67
X
XML file for configuration 33