4-30 Lexmark™ E260, E260d, E260dn
4513-200, -220, -230
Main motor gear drive removal
1. Remove the left side cover. See “Left side cover removal” on page 4-24.
2. Open the front access door, and disconnect the fuser link (A).
3. Place the printer on its right side.
Note: Be careful to not mar the finish of the printer.
4. Remove the four screws (B) from the main motor gear drive.
Note: The picture below shows the E360d, E360dn printer. The main motor gear drive removal is the same for
all models.
To Next Page
Loading...
