Diagnostic aids 3-7
4513-220, -230
Network
Use the network menu to change printer settings on jobs sent through a network port (either standard network or
network opt <x>).
Menu item Use setting to Values
NPA Mode Send print jobs to the printer and query printer status information
simultaneously.
Off
Auto (default)
MAC Binary PS Configure the printer to process Macintosh binary PostScript print
jobs.
Off—The printer filters
PostScript print jobs using
Standard protocol.
On—The printer processes raw
binary PostScript print jobs from
computers using the Macintosh
operating system. This setting
often causes Windows print jobs
to fail.
Auto (default)—The printer
processes print jobs from
computers using either
Windows or Macintosh
operating systems.
Set Card Speed Automatically detect the connection speed of the network.
This setting can be disabled to set the speed manually.
Auto (default)—the printer
detects current network speed.
10Mbps, half duplex—forces the
printer to try to connect to the
network only at 10Mbps, half
duplex.
10Mbps, full duplex—forces the
printer to try to connect to the
network only at 10Mbps, full
duplex.
100Mbps, half duplex—forces
the printer to try to connect to
the network only at 100Mbps,
half duplex.
100Mbps, full duple—forces the
printer to try to connect to the
network only at 100Mbps, full
duplex.