1-6 Service Manual
4512-630
Types of print media
Ensure trays are properly loaded. Never mix media types within a tray.
Source Sizes Types Weight
6
Input capacity
(sheets)²
Input tray 1
(250-sheet tray)
A4, A5, A6³, JIS, B5,
letter, legal,
executive, folio,
statement
Paper, labels¹,
transparencies
60—90 g/m
2
(16—24 lb)
250 paper
50 labels¹
50 transparencies
2nd Drawer option
(550-sheet only–
E352dn only)
A4, letter, legal, A5,
JIS, B5, executive,
folio, statement
Paper, labels¹,
transparencies
60—90 g/m
2
(16—24 lb)
550 paper (20 lb)
50 labels¹
50 transparencies
Manual feed input
7
A4, A5, A6³, JIS, B5,
letter, legal,
executive, folio,
statement
Paper, labels¹,
transparencies, card
stock,
4
envelopes
5
60—163 g/m
2
(16—43 lb)
1 sheet (all medias)
Envelopes
5
:
monarch (7 ¾), 9,
Com-10’, C5, B5, DL
Minimum feed size:
76 X 127mm
Universal (max)
paper:
216 X 357mm
¹ Single sided paper labels are supported for the occasional use of less than 20 pages per month. Labels such as vinyl
labels, pharmacy labels or dual-sided labels are not supported.
² For 20 lb print material, unless otherwise noted.
³ A6 long grain media support/short grain A6 not supported
4
Card stock up to 90# index. Designed to exit rear door. Short grain is recommended.
5
20 lb envelopes are recommended
Wrinkling may also occur on the front side, but away from address or return address areas. Slight wrinkling (nit in
address areas) is permitted on 24# envelopes. Use envelopes that lay flat when individually placed on a table facedown.
The distance of any edge or corner from the table should be less than 3 mm.
6
This refers to paper only. Treeing may occur on 16# paper.
7
Input using manual feeder is reduced to 1/2 speed
To Next Page
Loading...
