3-18 Service Manual
4512-630
INPUT TRAY TESTS
Feed Tests (input tray)
This test lets the servicer observe the paper path as media is feeding through the printer. A blank sheet of paper
feeds through the printer as the laser turns off during this test. The paper is placed in the output bin.
To run the Input Tray Feed Tests:
1. Select Feed Tests from INPUT TRAY TESTS.
2. Select the input source from the sources displayed on the Feed Tests menu. All installed sources are listed.
3. Select either Single or Continuous.
• Single–feeds one sheet of media from the selected source.
• Continuous–media continues feeding from the selected source until Stop ( ) is pressed.
To Next Page
Loading...
