If the printer control panel light sequence matches the light sequence in the preceding illustration, then
press
twice quickly to see the supplemental light sequence.
‑ On
‑ On
‑ On
‑ On
If the supplemental light sequence matches the light sequence in the preceding illustration, then try one or
more of the following:
• Load the correct size of paper.
• From the printer control panel, press to clear the light sequence and print using a dierent tray.
• Check the length and width guides and make sure the paper is loaded properly in the tray.
• Make sure the correct paper size and type are specified in Print Properties or the Print dialog settings.
• Make sure the correct paper size and type are specified in the Paper menu on the printer control panel:
– If the printer is on a network, then access the Embedded Web Server.
1 Open a Web browser, and then type the printer IP address in the address
field.
Notes:
• Print a network setup page or menu settings page, and then locate IP address in TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > Paper Menu.
– If the printer is connected to a computer by a USB or parallel cable, then access the Paper menu
through the Local Printer Settings Utility for Windows or through Printer Settings for Macintosh.
Troubleshooting 120
To Next Page
Loading...
