Lexmark MS310 Series - Network;Ports Menu

Network/Ports menu
Standard USB menu
Use To
PCL SmartSwitch
On
O
Set the printer to automatically switch to PCL emulation when a print job
received through a USB port requires it, regardless of the default printer
language.
Notes:
• On is the factory default setting.
• If PCL SmartSwitch is enabled, then the printer uses PCL emulation.
• If PCL SmartSwitch is disabled, then the printer does not examine
incoming data and it uses the default printer language specified in the
Setup menu.
PS SmartSwitch
On
O
Set the printer to automatically switch to PS emulation when a print job received
through a USB port requires it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• If PS SmartSwitch is enabled, then the printer uses PostScript emulation.
• If PS SmartSwitch is disabled, then the printer does not examine incoming
data and it uses the default printer language specified in the Setup menu.
USB Buer
Disabled
Auto
3K to [maximum size allowed]
Set the size of the USB input buer.
Notes:
• Auto is the factory default setting.
• Disabled turns
o
job
buering.
• The USB buer size value can be changed in 1KB increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link
buers,
and whether Resource Save is
set to On or O.
• To increase the maximum size range for the USB
Buer,
disable or
reduce the size of the parallel, serial, and network buers.
• The printer automatically restarts when the setting is changed. The menu
selection is then updated.
Understanding the printer menus 57