Configuring Sleep and Hibernate modes
Sleep and Hibernate are low‑power operating modes.
Notes:
• If your printer is connected directly to a computer, access the Sleep and Hibernate mode settings using
the Local Printer Settings Utility or Printer Settings depending on your operating system.
• Three days is the default amount of time before the printer enters Hibernate mode.
• Wake the printer from Hibernate mode before sending a print job. A long press of the Sleep button
wakes the printer from Hibernate mode.
• If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1 Open a Web browser, and then type the printer IP address in the address
field.
Notes:
• Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > General Settings > Sleep Button Settings.
3 From the “Press Sleep Button” or “Press and Hold Sleep Button” menu, select Sleep or Hibernate.
4 Click Submit.
Adjusting Sleep mode
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
• Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > General Settings > Timeouts.
3 In the Sleep Mode field, enter the number of minutes you want the printer to wait before it enters Sleep
Mode.
4 Click Submit.
Using the printer settings on the computer (Windows only)
•
Access the Setup menu using the Local Printer Settings Utility.
Saving money and the environment 74
To Next Page
Loading...
