Repeating defects appear on prints
Action Yes No
Step 1
Measure the distance between the defects.
Check for a distance between the defects that equals:
• 97 mm (3.82 in.)
• 47 mm (1.85 in.)
• 38 mm (1.5 in.)
Is the distance between defects equal to one of the listed
measurements?
Go to step 2.
1 Check if the
distance
between the
defects equal to
80 mm (3.15 in.)
2 Take note of the
distance, and
then contact
customer
support at
http://support.l
exmark.com or
your service
representative.
Step 2
Replace the imaging unit, and then resend the print job.
Do the repeating defects still appear?
Contact
customer
support at
http://support.lexm
ark.com or your
service
representative.
The problem is
solved.
Print is too dark
ABC
DEF
Troubleshooting 166
To Next Page
Loading...
