Lexmark MS310 Series User Manual

Action Yes No
Step 4
Check if the paper loaded in the tray has texture or rough finishes.
Are you printing on textured or rough paper?
From the Paper
Texture menu,
change the texture
settings to match the
paper you are
printing on. To
access the Paper
Texture menu, do
either of the
following:
• If the printer is on
a network, then
open a Web
browser and type
the printer IP
address in the
address field.
Then navigate to
Settings > Paper
Menu > Paper
Texture.
Note: If you do
not know the IP
address of the
printer, then print
a network setup
page and locate
the IP address in
the TCP/IP
section.
• If the printer is
connected to a
computer by a
USB or parallel
cable, then open
the Local Printer
Settings Utility for
Windows or
Printer Settings
for Macintosh.
Go to step 5.
Step 5
a Load paper from a fresh package.
Note: Paper absorbs moisture due to high humidity. Store
paper in its original wrapper until you use it.
b Resend the print job.
Is the print still too dark?
Go to step 6. The problem is
solved.
Troubleshooting 168

Lexmark MS310 Series Specifications

General

Print Technology	Monochrome Laser
Processor Speed	800 MHz
Monthly Duty Cycle	Up to 50, 000 pages
Recommended Monthly Page Volume	500 - 2, 500 pages
Connectivity	USB 2.0, Ethernet
First Page Out Time	As fast as 6.5 seconds
Print Resolution	1200 x 1200 dpi
Memory	128 MB
Duplex Printing	Standard
Input Capacity	250 sheets
Output Capacity	150 pages
Media Types Supported	Plain paper, envelopes, card stock, labels
Media Sizes	Letter, Legal, Executive, Statement, Oficio, A4, A5, A6, B5 (JIS), B6 (JIS), Envelope (No. 10, Monarch, DL, C5)
Operating Systems Supported	Windows, macOS, Linux
Dimensions	399 mm