Lexmark W820 - Flash Test

Diagnostic Aids 3-23
4025-XXX
Once Go is selected, the following screen is displayed to indicate the operation has
begun.
If the test passes, then the following message is displayed. Press Go, Return, or Stop to
return to the DEVICE TESTS screen.
If the test fails, then the following message is displayed. Press Go, Return, or Stop to
return to the DEVICE TESTS screen.
Because of the nature of this operation, cancelling of this test is not allowed.
Flash Test
This test causes the file system to write and read data on the flash to test the flash
device. This test destroys all data on the flash.
Note: This test leaves the flash unformatted. The CE or user must reformat the flash
using the Format Flash menu operation.
To run this test, select Flash Test from the DEVICE TESTS menu. The following message
is displayed to warn the customer that all flash contents will be lost. To continue with the
test, press Go. To exit the test immediately and return to the DEVICE TESTS screen,
press Return or Stop.
The following message is displayed while the test is running. The Power indicator blinks
while the test is in progress.
If the test passes, then the following message is displayed. Press Go, Return, or Stop to
return to the DEVICE TESTS screen. then the Power indicator is turned on solid.
Disk Test/Clean
Testing...
Disk Test/Clean
Test Passed
Disk Test/Clean
Test Failed
Files will be
Lost. Go/Stop?
Flash Test
Testing...
Flash Test
Test Passed