Lexmark W820 - Rear Cover 1 TM

4-12 Service Manual
4025-XXX
Rear Cover 1TM
Removal
1. Disconnect all option plugs from the Plug Jack located at the rear of the printer.
2. Remove the two screws securing the Rear Cover 1TM to the printer frame.
3. Lift up on the Cover and remove it from the printer frame.
Replacement
1.
Reinstall the Rear Cover 1TM by first hooking the bottom edge of the Cover onto the
frame, and then pressing the top of the Cover against the frame.
2. Use two screws to secure the Cover to the printer frame.
3. Reconnect the option plugs to the Plug Jack located at the rear of the printer.