General Information 1-69
4025-XXX
General Specifications
Category Specification for product
Standard configuration Print Engine with Tray 1 (500 sheet), Tray 2 (500 sheet), MP
Feeder (50 sheet), and the Offset Unit
Printing method Xerography
Exposure method Data modulated (off/on) laser beam
Laser specifications Class 3B, 5 milliwatt semiconductor laser diode
Resolution of printed image 600 dpi (dots per inch)
Development method Mono Component Dry Toner
Fusing method Heat and pressure
Warm-up time From either a cold start or from sleep mode (with an ambient
temperature of 22°C) to Ready to Print within 1 minute
Power supply requirements 110V printer: 100 /115VAC (±10%) @ 50/60 Hz (±3 Hz)
240V printer: 220 VAC (±10%) @ 50/60 Hz (±3 Hz)
Power supplied to the ESS PWB 5VDC @ 8A
Power consumption of the print
engine during an average print cycle,
assuming an ESS PWB voltage of
5VDC and current of 8.0 amperes.
120VAC:900 watts / 7.8A
240VAC:900 watts / 4.3A
Size and weight of base engine with
the MP Feeder Tray retracted.
Height: 486 mm / 19.1 inches ±1%
Width: 642 mm / 25.3 inches ±1%
Depth: 523 mm / 20.5 inches ±1%
Weight - 110V model: 45 kg / 99.2 lbs ±1%
Weight - 210V model: 47.5 kg / 104.7 lbs ±1%
Minimum space requirements;
measured from the printer covers to
the wall
Front: 460 mm / 18.1 inches
Back: 200 mm / 7.9 inches
Right: 200 mm / 7.9 inches
With Finisher installed: 800 mm / 35.1 inches
Left: 360 mm / 14.2 inches
With Duplex Unit installed: 640 mm / 25.2 inches
Operating environment needed for
normal operation
5~30
°C @ 15~85% RH (no condensation)
0~8200 feet above sea level
No direct sunlight (less than 3,000 LUX)
Maximum paper size Tray 1 and Tray 2: 279.4 mm x 431.8 mm / 11 x 17 inches
MP Feeder: 279.4 mm x 431.8 mm / 11 x 17 inches
Maximum printable area 279.4 mm x 431.8 mm / 11 x 17 inches. Print quality may
deteriorate within a 4 mm / 0.157 inch margin around the
sheet of paper
To Next Page
Loading...
