Lexmark W820 - Tray 2 Lift Motor

4-34 Service Manual
4025-XXX
Tray 2 Lift Motor
Removal
1. Slide Tray 2 halfway out of the printer.
2. Remove the Rear Cover.
3. Disconnect the J241 from the rear of Tray 2 Lift Motor.
4. Remove the three long screws securing the Motor to the printer frame.
5. Slide the Motor out to remove it.
Replacement
1. Reinstall the Lift Motor onto the printer frame. Be careful not to trap any wires
between the Motor and the frame.
2. Use three long screws to secure the Motor to the frame.
3. Reconnect J241 to the rear of the Lift Motor.
4. Reinstall the Rear Cover.
5. Slide Tray 2 into the printer.