4-10 Service Manual
4025-XXX
Right Cover
Removal
1. Remove the two screws securing the Top Cover to the Right Cover.
2. Carefully raise the right end of the Top Cover and at the same time lift the Right
Cover up and away from the printer frame.
Replacement
1. Raise the right end of the Top Cover.
2. Press the Right Cover against the printer frame and slide the Cover down until the
two hooks at the bottom lip of the Cover are hooked in place under the Tray 1 Cover.
3. Press the top of the Right Cover against the printer frame while you lower the Top
Cover.
4. Make sure the Top Cover screw tabs rest on top of the Right Cover.
5. Use two screws to secure the Right Cover (and Top Cover) to the printer frame.
To Next Page
Loading...
