3-26 Service Manual
4025-XXX
a. Digit 1 refers to the leftmost digit of the Configuration ID and digit 6 refers to the last
digit of the Configuration ID.
b. Input trays refers to all trays below the printer including any trays shipped standard with
the printer, (that is Tray 1 through Tray 5). All machines support an envelope feeder.
c. Output units refers to the sum of each installed output device assigned unit value. This
sum may not exceed the value specified by Digit 3.
d. Tray Input Source Factory Defaults: Tray 1 Paper Type=Plain Paper, Tray 2 Paper
Type=Custom Type 2, Tray 3 Paper Type=Custom Type 3, Tray 4 Paper Type=Custom
Type 4 and Tray 5 Paper Type=Custom Type 5.
e. The Checksum is a single digit, calculated using mod-16 addition on each of the other
5 digits.
Setting the Page Count
The printer page count can be changed using the Diagnostics menus. This menu is used
by the CE to reset the Page Count setting whenever the engine card is replaced. The
engine card contains the printer NVRAM memory. When Page Count is selected from the
PRINTER SETUP menu, the current page count is displayed:
The leftmost digit (‘1’ in this example) blinks, indicating it is the first digit to be changed. To
change the value, press Menu until the value you want is displayed. Press Select to
move to the next digit. The next digit (‘2’ in this example) blinks. Continue modifying each
digit using this method. To skip a digit (that is and keep its current value), press Select.
5 Bit 3 Operator Panel Configuration 0 = The panel character
ROM supports the modified
Code Page 850 and
Katakana encodings.
1 = The panel character
ROM supports the modified
Code Page 850, ISO Cyrillic,
ISO Latin 2 and ISO Latin 5
encodings.
Bit 2 Unused All unused bits must be set to
0.
Bit 1 Unused All unused bits must be set to
0.
Bit 0 Unused All unused bits must be set to
0.
6 Bits 3-0 Checksum
e
0000 through 1111
Page Count
=1234567*
Digit
a
Bit Position Printer Setting Values
To Next Page
Loading...
