Lexmark W820 - Page 228

4-20 Service Manual
4025-XXX
Removal
1. Remove the Duplex Unit, if one is installed.
2. Remove the EP Cartridge.
3. Remove Tray 1 and Tray 2.
4. Remove the Left Upper Cover Assembly.
5. Remove the Rear Cover Assembly.
6. Remove the MP Feeder Support Assembly.
7. Remove the retaining clip from the docking stud that is located at the lower right of
Feeder 1 and remove the stud.
8. Remove the screw securing the docking clip that is located at the upper left of
Feeder 2 and remove the clip.
9. Disconnect J463, J464, J466, and J467 from the I/O PWB.
10. Remove the screw securing the Option Connector Bracket to the frame, and remove
the Bracket.
11. Remove the screw securing the retaining clip that is located under the Option
Connector Bracket, and remove the clip (Figure 1).
12. Remove Tray 1 Lift Motor.
CAUTION: The printer is heavy and requires two people to lift it. Do not attempt to lift the
printer by yourself.
13. Lift the printer off of Tray 2.
14. Set the printer, with the right side down, on a level and stable work surface.
15. Remove the Support Assembly Spring.
16. Remove Tray 1 Feed Clutch, along with the Gear and Bearing.
17. Remove the four screws securing Tray 1 Take Away Roll Assembly to the rear of the
frame.
18. Remove the two screws securing Tray 1 Take Away Roll Assembly to the front of the
frame.
19. Locate the two plastic mounting pins, located at each end of the Assembly, that
secure the top of the Assembly to the bottom of the printer frame.
20. Press the two plastic mounting pins out of the mounting holes, and pull Tray 1 Take
Away Assembly away from the printer.