Lexmark W820 - Page 268

4-60 Service Manual
4025-XXX
Removal
1. Open the Duplex Unit if one is installed.
2. Open the Left Upper Cover.
WARNING: Do not attempt to remove the EP Cartridge without first opening the Left
Upper Cover.
3. Open the Front Cover.
4. Pull up on the handle and slide the EP Cartridge half way out of the printer.
5. Hold on to the top handle and slide the EP Cartridge out of the printer.
6. If you are removing the EP Cartridge as part of another removal and replacement
procedure, place the EP Cartridge in a covered box or cover it with a sheet of
opaque plastic to protect it from light.
Replacement
1. Make sure the Duplex Unit and the Left Upper Cover are both open.
WARNING: Do not attempt to install the EP Cartridge without first opening the Left
Upper Cover.
2. Remove the EP Cartridge from the protective shipping bag.
3. Carefully remove the paper seal that is fastened to the EP Cartridge with adhesive
tape.
4. Hold the EP Cartridge by the top handle and carefully slide the EP Cartridge into the
printer.
5. Release the top handle and allow it to fold out of the way, then slide the EP Cartridge
the rest of the way into the printer.
6. Push firmly on the end of EP Cartridge to make sure it is correctly seated in the
printer.
7. Hold the seal of the EP Cartridge and pull out, to make sure the EP Cartridge is
latched in place.
WARNING: Do not hold the handle when pulling out. You will release the EP Cartridge
latch.
8. Close the Front Cover.
9. Close the Left Upper Cover
10. Close the Duplex Unit if one is installed.