159
3-3. Adjusting the seats
3
Operation of each component
RX350_U_OM48E90U
■ The rear seatbacks can be raised when (power seat)
When all of the following conditions are met, a rear seat operation switch can be used to
return the rear seatback:
● When using the rear seat operation switch (luggage compartment): The back door is
open.
● The other seat operation switch for the seat to be operated is not being pressed.
When the engine switch is in IGNITION ON mode, one of the following conditions must
also be met in order for the power seat to be operated:
• The parking brake is engaged.
• The brake pedal is depressed.
• The shift lever is in P.
■ Fully reclining the rear seatback (power seat)
■ Power seat operations (if equipped)
If a seat cover or seat cushion has been put on the seat, it may not operate properly.
When folding down the rear seatback, make sure that there is nothing on the seat that
would interfere with the operation.
■ Rear seatback jam protection function (power seat)
When folding down or raising the rear seatback, if an object is detected between the rear
seatback and seat cushion, the rear seatback will stop and then move in the opposite
direction slightly.
A buzzer will sound continuously when the rear seatback stops and intermittently when
moving in the opposite direction.
● When the engine switch is turned off or in
ACCESSORY mode
● When using the rear seat operation switch
(rear seat): The rear seatback is in a position
within the range A shown in the illustration.
● When using the rear seat operation switch
(rear seat): The rear door nearest to the seat to
be operated is open.
Operate the rear seat operation switch (rear
seat) to recline the rear seatback and stop it
partway. To set the rear seatback to the rear-
most position, press the button again.
To Next Page
Loading...
