LG MultiSITE MS8000 Series - Page 31

31
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
2/9 Configuration
Mode button Normal
Auto mode Enabled
Standby mode
Absolute
Standby diff. 2.0 °F
Table 14: MS8350 Conguration 2 / 9 Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
Mode Button
Default Value: Normal
Changes the behavior of the system mode button functionality and hides / shows tempera-
ture setpoints on main screen.
Normal: System mode button switches between “Off”, “Auto”, “Cool” and “Heat”. Also
displays temperature Setpoints on main screen.
Off-Auto: System mode button switches between “Off” and “Auto”. Hides temperature
Setpoints on main screen.
Setting “Mode button” to “Off-Auto” forces the “Setpoint func.” parameter to “Attach SP”.
Choices: Normal or Off-Auto
Auto Mode (Auto Mode Enable)
Default Value: Disabled
Enables auto function for the mode button. For sequences 2, 4, and 5 only
Enabled: auto active (Off-Cool-Heat-Auto)
Disabled: auto not active (Off-Cool-Heat)
Choices: Enabled or Disabled
Standby Mode (Standby Mode
Configuration)
Default Value: Absolute
Standby setpoints used for control.
Absolute: Standby entered values are used for standby mode.
Offset: Occupied setpoints +/- Standby diff. used for standby mode.
Choices: Absolute or Offset
Standby Diff. (Standby Temperature
Differential)
Default Value: 4°F (2°C)
When Standby mode is set to “offset”, standby setpoints are calculated as follows:
Standby cool: Cool setpoint + Standby diff.
Standby heat: Heat setpoint - Standby diff.
Range: 1 to 5°F (0.5 to 2.5°C)
MS8350 Configuration 2 / 9
CONFIGURATION SCREENS
MS8350 Conguration 2 / 9
Figure 25: MS8350 Conguration 2 / 9 Display.
For MS8350 Only