67
INSTALLER SETTING
ENGLISH
Central Control Address
When connecting the central control, set the central control address of the unit.
• In the installer setting list, select Central Control Address category, and press [OK] button to
move to the detail screen.
OK
66
INSTALLER SETTING
Dry Contact Mode
Dry contact function is the function that can be used only when the dry contact devices is
separately purchased and installed.
• Change setting values using [<,>(left/right)] button.
Value
Auto
manual
NOTE
For dry contact mode related detail functions, refer to the individual dry contact manual.
What is dry contact?
It means the contact point signal input when the hotel card key, human body detection
sensor, etc. are interfacing with the air conditioner.
Added system functionality by using external inputs (dry contacts and wet contacts).
NOTE
This function is not available for monobloc
NOTE
Enter address code as hexadecimal value
Front: Central Control Gr. No.
Back side: Central control indoor the number
To Next Page
