99
INSTALLER SETTING
ENGLISH
Cooling temp. setting
• At the leaving water control in cooling mode, the control reference water temperature position
setting
- If the air / leaving water temperature selection setting is set to leaving water temperature
• Change setting values using [<,>(left/right)] button
Value
Outlet (Default) Inlet
98
INSTALLER SETTING
Pump setting in heating
• It is a function to help the water pump's mechanical life by putting the water pump's rest time
• Installer setting function to set water pump operation / delay time option in heating mode
• In the installer setting list, select Pump setting in heating category, and press [OK] button to
move to the detail screen.
OK
Type Time setting Operation continue
On 1 Minute~60 minutes -
Off 1 Minute~60 minutes -
To Next Page
