Lighthouse Handheld 2016 - Page 85

Operation
248083400-1 Rev 7
4-57
Note: If the entered Area
values needs more
locations than available, a
“Not enough locations”
message will be displayed
and the user will be asked
to enter a lesser area.
• Press the AREA button to display screen shown in Figure 4-70.
Figure 4-70 Reports Area Setup Screen
• Select the appropriate unit of measure (ft
2
or m
2
) and type in the
area using the keypad. Press ENTER to display the value on the
screen.
• Press the BACK button.
• Press the STATUS button to display screen shown in Figure 4-71.
Note: The minimum area
that can be entered is 6 ft
2
or
1 m
2
.
The maximum area that can
be entered depends on the
number of locations available
on the unit.
With all 200 locations
available, the Max area that
can be entered is limited to a
5 digit value for ft2 and a 4
digit value for m2.
Figure 4-71 Reports Room Status Scree
• Select appropriate room status (As Built, At Rest, In Operation).
• Press the BACK button.