3. Product Overview HDMI-3D-OPT series – User's Manual 19
Automatic Input Selection - Example
The Concept
If there is no other source connected to the transmitter, but the MacBook, DP input will be automatically
will be switched to the optical output. If the Blu-ray player is connected on the HDMI input of the transmitter,
it will be switched to the optical output – independently of the presence of other video signals.
Settings
▪ Optical output: Set the Autoselect to Enabled. Set Autoselect mode to Priority detect. The priorities are
the following (the lowest number means the highest priority):The priorities are the followings:
Source device Input port Priority
MacBook I1 (DP IN) 2
PC 1
Blu-ray player I2 (HDMI IN) 0
Priorities can be set in Lightware Device Controller software, see related settings in the and
Digital Audio Outputs sections.
compliant (Human Interface Device) devices to transmit USB signal between the source and sink devices.
The transmitter connects to the controlled device (e.g. PC) and the controlling devices (e.g. computer
mouse, keyboard, touch panel) are connected to the receiver.
ATTENTION! Only HID-compliant devices are supported by the extenders. Non-HID devices (USB sticks,
webcams, etc) will not be working with the extenders.
Transparent and Composite mode. The following
sections show the difference between the two modes:
HDMI-3D-OPT-RX150RA
receiver
SW4-OPT-TX240RAK
transmitter
Blu-ray player
FIBER OPTICALHDMI IN HDMI OUT
Projector
POWER
HDCP
RS-232
FUNC.
USB
CONT.
HDMI
SIGNAL
LASER
HOTPLUG
EMULATE
USB LINK
FIBER LINK
PC
DVI-D IN
MacBook
DP IN
:
:
1 4
5
3
2
USB
Autoselect
SHOW
ME
AUDIO
SELECT
VIDEO
SELECT
VIDEO VIDEO VIDEOAUDIO AUDIO AUDIO VIDEO
AUDIO
HDCP AUDIO1
DP IN DVI-D IN
RST
AUDIO2
AUDIO1 IN
HDMI2 INHDMI1 IN
Transparent Mode
Transparent mode is a simple USB data transmission between the extenders. The same data is transmitted
The content of the transmitted packets are unknown to the
Lightware infrastructure so
▪ Supports all HID-compliant devices.
▪
you switch a crosspoint between two sources, the connected mouse and keyboard will be detected
as a new hardware in the operating system.
Composite Mode
The composite mode is an advanced data transmission method, recommended for most users. The devices
use their own data packets during data transmission. Thus, the content of the transmitted packets is known
to the Lightware infrastructure.
▪
▪ No driver software is needed for the connected devices. The operating system uses the driver of the
extender to establish the connection for the USB devices.
section.
USB KVM - Example 1
The Concept
line from the receiver which is connected to the controller devices (to the keyboard and the mouse) to the
meters.
HDMI-3D-OPT-RX150RA
receiver
HDMI-3D-OPT series
transmitter
FIBER OPTICALUSB USB
POWER
HDCP
RS-232
FUNC.
USB
CONT.
HDMI
SIGNAL
LASER
HOTPLUG
EMULATE
USB LINK
FIBER LINK
Keyboard / MousePC
:
:
1 4
5
3
2
USB
Autoselect
SHOW
ME
AUDIO
SELECT
VIDEO
SELECT
VIDEO VIDEO VIDEOAUDIO AUDIO AUDIO VIDEO
AUDIO
HDCP AUDIO1
DP IN DVI-D IN
RST
AUDIO2
AUDIO1 IN
HDMI2 INHDMI1 IN
To Next Page
Loading...
Need help?
General
