HDMI-3D-OPT series – User's Manual 67
Analog Audio Input Level Settings by Steps
INFO: The following settings are valid only for analog audio input ports of the transmitters.
Volume in dB
Command format: CALL●
n
Response format: m0●
n
Parameters:
Example:
˃ CALL /MEDIA/AUDIO/I5:stepVolumedB(-1)
˂ m0 /MEDIA/AUDIO/I5:stepVolumedB
Explanation
Volume in Percent
Command format: CALL●
n
Response format: m0●
n
Parameters:
Example:
˃ CALL /MEDIA/AUDIO/I5:stepVolumePercent(5)
˂ m0 /MEDIA/AUDIO/I5:stepVolumePercent
Explanation
Balance
Command format: CALL●
n
Response format: m0●
n
Parameters:
Balance is shifted to left or right depends on the given value. -100 means
left balance, 100 means right balance, step is 1. Center is 0 (default).
Example:
˃ CALL /MEDIA/AUDIO/I5:stepBalance(1)
˂ m0 /MEDIA/AUDIO/I5:stepBalance
Explanation: The balance is shifted to right with 1 step.
Analog Audio Output Level Settings
INFO: The following settings are valid only for analog audio output port of the receiver.
Command format: SET●
n
Response format: pw●
n
Parameters:
value.
Example:
˃ SET /MEDIA/AUDIO/O3.VolumedB=-15
˂ pw /MEDIA/AUDIO/O3.VolumedB=-15.00
Command format: SET●
n
Response format: pw●
n
Parameters:
The value is rounded up if necessary to match with the step value.
Example:
˃ SET /MEDIA/AUDIO/O3.VolumePercent=50
˂ pw /MEDIA/AUDIO/O3.VolumePercent=50.00
Balance
Command format: SET●
n
Response format: pw●
n
Parameters:
Sets the balance; -100 means left balance, 100 means right balance, step
is 1. Center is 0 (default).
Example:
˃ SET /MEDIA/AUDIO/O3.Balance=0
˂ pw /MEDIA/AUDIO/O3.Balance=0
To Next Page
Loading...
