Lightware HDMI-3D-OPT-RX150RA User Manual

 HDMI-3D-OPT series – User's Manual 76


7.9.1
Protocol Setting

7.9.2
BAUD Rate Setting

7.9.3
Databit Setting

7.9.4
Stopbits Setting


Parity Setting

7.9.6
RS-232 Operation Mode

Sending Message via the Communication Ports

7.10.1
Sending Message via TCP Port

7.10.2
Sending Message via UDP Port

7.10.3
Sending Message via an RS-232 Port



7.11.1
Set the Direction of a GPIO Pin

7.11.2
Set the Output Level of a GPIO Pin

7.11.3
Toggle the Level of a GPIO Pin

EDID Management

7.12.1


7.12.2


7.12.3


7.12.4
Emulating an EDID to an Input Port


Emulating an EDID to All Input Ports

7.12.6
Copy an EDID to User Memory

7.12.7
Deleting an EDID from User Memory

7.12.8
Resetting the Emulated EDIDs






Lightware HDMI-3D-OPT-RX150RA Specifications

General

Brand	Lightware
Model	HDMI-3D-OPT-RX150RA
Category	Receiver
Language	English