Lightware MMX6x2-HT200 - Network Configuration; Query the DHCP State; Change the DHCP State; Query the IP Address

MMX6x2-HT
User’s Manual
Section 8. LW3 Programmers’ reference Page 99 / 119
8.8. Network configuration
8.8.1. Query the DHCP state
Command format
GET/MANAGEMENT/NETWORK.DhcpEnabled
Response format
pw/MANAGEMENT/NETWORK.DhcpEnabled=true|false
Example
> GET/MANAGEMENT/NETWORK.DhcpEnabled
< pw/MANAGEMENT/NETWORK.DhcpEnabled=true
8.8.2. Change the DHCP state
Command format
SET/MANAGEMENT/NETWORK.DhcpEnabled=true|false
Response format
pw/MANAGEMENT/NETWORK.DhcpEnabled=true|false
Example
> SET/MANAGEMENT/NETWORK.DhcpEnabled=false
< pw/MANAGEMENT/NETWORK.DhcpEnabled=false
8.8.3. Query the IP address
Command format
GET/MANAGEMENT/NETWORK.IpAddress
Response format
pr/MANAGEMENT/NETWORK.IpAddress=<IP_address>
Example
> GET/MANAGEMENT/NETWORK.IpAddress
< pr/MANAGEMENT/NETWORK.IpAddress=192.168.0.102
8.8.4. Change the IP address (static)
Command format
SET/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
Response format
pw/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
Example
> SET/MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.105
< pw/MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.105
8.8.5. Query the subnet mask
Command format
GET/MANAGEMENT/NETWORK.NetworkMask
Response format
pr/MANAGEMENT/NETWORK.NetworkMask=<netmask>
Example
> GET/MANAGEMENT/NETWORK.NetworkMask
< pr/MANAGEMENT/NETWORK.NetworkMask=255.255.255.0