Page 22 / 119 Section 4. TPS matrix concept
4.3.2. The Autoselect feature
There are three types of Autoselect as follows:
First detect mode: Selected input port is kept connected to the output while it has an
active signal.
Priority detect mode: Always the highest priority active input is selected to transmit.
Last detect mode: Always the last attached input is selected to transmit.
INFO
An input port is active if there is a valid signal on it.
Figure 4-5. Flowchart of the Autoselect modes
INFO
The input ports, where the priority is set to 31 will not be scanned.
To Next Page
Loading...
