Page 42 / 119 Section 5. Installation and operation
5.4.5. Outputs menu
HDMI outputs (HDMIOUT1 and HDMIOUT2)
HDMI Mode: Auto / DVI / HDMI. The setting determines the output signal type.
HDCP Mode: Auto / Always
Audio Mode: Passthrough / AUX1 / AUX2 / AUX3 / AUX4. The desired audio can
be selected to the video on the given HDMI output, thus, the setting will override
the input setting. In Passthrough mode, the setting on the input port will be valid.
Pwr5V Mode: Auto / Always on / Always off. The setting lets the source and the sink
devices be connected – independently from the transmitted signal.
TPG Mode: Disabled / Enabled. The test pattern generator can be switched on/off.
TPS outputs (TPSOUT3 and TPSOUT4)
HDMI Mode: Auto / DVI / HDMI. The setting determines the output signal type.
HDCP Mode: Auto / Always
Pwr5V Mode: Auto / Always on / Always off. The setting lets the source and the sink
devices be connected – independently from the transmitted signal.
TPG Mode: Disabled / Enabled. The test pattern generator can be switched on/off.
PoE Enable: Enabled / Disabled
PoE Status: ON / OFF. If power is sent via the current TPS output, the status is ON.
TPS Mode: Auto / HDBaseT / Long reach / LPPF1 / LPPF2
TPS Status: Disconnected / Connected (Read-only parameter)
Analog audio outputs (AUXOUT1 and AUXOUT2)
Volume: from -57 to 0 dB, step = 1 dB
Balance: from 0 to 100, step = 1 (50 = center)
Gain: from 0 to 3 dB, step = 1 dB
5.4.6. Signal info menu
Basic information is displayed about the transmitted audio and video in the submenus:
image resolution, refresh rate, color depth and audio type.