Chapter 6-6-4. LOG View
Operational log, video lose event, abnormal power off, and other DVR events can be
reviewed by LOG View menu item.
Chapter 6-6-5. Factory Reset
A user may want to restore manufacturing default settings. A confirm message shows up for
final verification. To perform this task, please select Factory Reset at System->Factory
Reset and press Enter button.
Chapter 6-6-6. DVR ID
Each DVR can be assigned by a unique DVR ID accessed by the remote controller. With a
unique DVR ID set, the remote controller issues commands to a particular DVR. The rest of
DVRs are in sleep mode.
To operate addressable DVR control feature, please refer to chapter 1 Addressable DVR
Control Button.
Chapter 6-6-7. Video System
The DVR supports both NTSC and PAL video systems. The DVR allows switching from one
video system to another without rebooting. To change video system, press Left or Right
button at System->Video System.
Chapter 6-6-8. Firmware Update
Firmware update allows one to upgrade the DVR’s firmware for improving system
performance. To perform firmware update, press Enter on Setup->System->Firmware
Update. There are two ways to perform firmware update via (1) USB flash disk at DVR site
and (2) HTML interface via network.
To perform firmware update using USB flash disk, please follow the instructions:
(1) Plug in a portable USB disk at the DVR’s USB port.
(2) Press Enter button at Start Update Firmware.
(3) After finishing transferring, remove the USB device and reboot the DVR.
Note: Factory reset does not affect IP address, video system, and language settings.
To Next Page
Loading...
