Linde H30D - Clean Sideshift (Special Equipment) and Grease, Check Fastening

5 Maintenance
Load lift system
Clean sideshift (special equipment)
and grease, check fastening
ENVIRONMENT NOTE
Observe information about working materials.
NOTE
The sideshift should be greas
ed whenever the
truck is washed. Use lubricat
ing grease com-
plying with the recommendati
ons for working
materials.
¾ Clean sideshift with steam jet.
¾ Check hydraulic lines for scuffing and re-
place if necessary.
¾ Check hydraulic connections
and fastening
elements for secure position
ing and wear
and tighten/replace if neces
sary.
¾ Check cylinders for leaks.
¾ Check piston rods for damage.
¾ Adjust the fork arms so that the
4 lubricating
nipples (1) are accessible.
¾ Let down sideshift until fork arms touch the
ground.
¾ Apply lubricating grease to lubricating nip-
ples (1) of support rollers on fork carriage
until grease escapes at the side.
¾ Apply lubricating grease to lu
bricating nip-
ples (2) of wear strips on fork c
arriage at top
until grease escapes at the sid
e.
180 Operating Instructions – 393 807 1001 EN – 08/2008