Operation 4
Special equipment
Lift mast positioning
Programming
The tilt angle sensor system enables a specific
lift mast tilt angle to be programmed. When
this function is active, the symbol (1) lights up
in the indicator unit.
¾ Tilt lift mast to required angl
e.
2
t3921358
¾ Press the button (2) in the front-left position
of the armrest for longer than 2 seconds.
The tilt angle is now
permanently stored. As
confirmation, a do
uble acoustic signal sounds
from the indicator
unit and the light in the but-
ton (2) flashes bri
efly several times.
The lift mast tilt angle is saved in relation to
the truck. The lift mast tilt angle in relation to
the ground depends on a variety of influencing
variables such as the tyre wear, tyre pressure
of pneumatic tyres and load, as well as the
unevenness and gradient of the ground.
Operation
NOTE
The lift mast positioning function is designed to
aid the driver and is purely a comfort feature.
The responsibility and control for activating
the required mast position always lie with the
driver.
Operating Instructions – 393 807 1001 EN – 08/2008 67
To Next Page
Loading...
