Circuit diagrams 7
Wiring diagram
Legend
5E11 55W left dipped beam, 276
5E12 55W right dipped beam, 278
5E13 5W left front side light, 280
5E14 5W right front side light, 285
5E15 10W left rear side light, 282
5E16 10W right rear side light, 287
5E17 10W left reversing light, 313
5E18 10W right reversing light, 315
5F5 15A fuse (lighting terminal 15), 291
5F6 10A fuse (lighting terminal 30), 295
5F7 5A fuse (brake light), 252, 308
5F8 7.5A fuse (left headlight), 276
5F9 7.5A fuse (right headlight), 278
5F10 5A fuse (left side light), 280
5F11 5A fuse (right side light), 285
5F13 10A fuse (warning light), 244
5H1 21W left front direction indicator, 293
5H2 21W right front direction indicator, 296
5H3 21W left rear direction indicator, 244, 291
5H4 21W right rear direction indicator, 246, 299
5H10 2W direction indicator control lamp, 248, 303
5H20 21W right brake light, 252, 308
5H21 21W left brake light, 254, 310
5K1 Flasher unit, 243-245, 297-300
5K2 Brake light relay, 250-252, 306-308
5K3 Hazard warning system relay for reversing,
270-272
5S11 Light switch, 276-282
5S12 Warning light switch, 291-300
5S13 Direction indicator switch, 294-296
5V1 Decoupling diode, 258
5V2 Decoupling diode, 264
5V3 Decoupling diode, 269
5V4 Decoupling diode, 269
X10 18-pin plug connector (for basic equipment),
241, 250, 272, 306
5X1 12-pin plug connector (overhead guard
lighting), 292-303
5X2 6-pin plug connector (rear lighting), 244–252
5X2.1 6-pin plug connector (rear lighting), 258, 264
5X2.2 6-pin plug connector (rear lighting), 258, 264
5X3 3-pin plug connector (reversing signal
transfer), 270
5X7 6-pin plug connector (left headlight), 276,
280, 293
5X8 6-pin plug connector (right headlight), 278,
285, 296
5X9 6-pin plug connector (warning light), 244,
248, 252
5X11 12-pin plug connector (higher lighting),
276-313
5X12 5-pin plug connector (right rear light), 287,
299, 308, 315
5X13 5-pin plug connector (left rear light), 282,
290, 310, 313
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(I) Warning light when reversing with brake
light (without lighting)
(a) For electronic controller N1:23
(b) For electronic controller N1:41
(II) Hazard warning system when reversing
(with lights)
(c) For electronic controller N1:23
(III) Higher lighting
(IV) Higher direction indicator and hazard
warning system
(V) Higher brake light
(d) For electronic controller N1:41
(VI) Higher reversing light
(e) For reversing signal special equipment
wiring diagram
Operating Instructions – 393 807 1001 EN – 08/2008 243
To Next Page
Loading...
