Circuit diagrams 7
Wiring diagram
Legend
7A2 Exchangeable particulate filter controller,
597-609
9A5 Monitor, 625-635
7B3 Exchangeable particulate filter buzzer, 610
9E6 Camera 1, 625-627
9E7 Camera 2, 630-632
F2 30A fuse, 567
F15 10A fuse, 601, 625
6F2 2A fuse, 574
7F4 2A fuse, 607
9F5 20A fuse, 617
G1 660W three-phase alternator with regulator,
562-565
G2 88Ah battery, 567
7H4 Indicator light (orange), 607
M1 1.7 kW starter motor, 569-571
9R1 Rear window heater, 617
S5 Battery main switch, 567
7S3 Exchangeable particulate filter switch,
596-597
7S4 Exchangeable particulate filter pressure
switch, 601-602
9S5 Rear window heater switch, 614-620
X10 18-pin plug connector (for basic equipment),
597, 601, 625, 632
6X1 10-pin plug connector, 577-590
7X6 9-pin plug connector (exchangeable partic-
ulate filter), 597-601
7X7 3-pin plug connector (reset switch), 596, 597
7X8 2-pin plug connector (pressure switch), 601,
602
9X26 5-pin plug connector (camera system),
625-627
9X27 5-pin plug connector (camera system),
630-632
9X28 5-pin plug connector (camera system),
625-627
9X29 3-pinplug connector (camera system),
625-634
Wire colours
BK Black
BN Brown
BU Blue
GN Green
GY Grey
OG Orange
RD Red
VT Violet
WH White
YE Yellow
The number in front of the wire colour refers
to the wire cross-section.
Wires with unspecified cross-section = 0.75
mm
2
Notes
(I) Battery main switch with indicator unit
voltage supply
(a) to wiring diagram for basic equipment
(II) Exchangeable particulate filter (fitted only to
the diesel version)
(b) Switch opens when the exchangeable
particulate filter is fitted and the cover is
closed (fitted only to the diesel version)
(c) Switch is shown in the pressure differential
OK position (fitted only to the diesel version)
(III) Rear window heater
(IV) Camera system
(d) To electronic control N1:22
Operating Instructions – 393 807 1001 EN – 08/2008 251
To Next Page
Loading...
